Table of Contents
Advertisement
CoS to Queue Mapping Table Page
The CoS to Queue Mapping Table page contains the following fields:
Class of Service—Specifies the CoS priority tag values, where zero is the lowest and seven is the highest.
l
Queue—Indicates the traffic forwarding queue to which the CoS priority is mapped. Four traffic priority queues are supported.
l
NOTE:
In a stacking configuration, Queue 4 is used for forwarding stacking traffic. Therefore, assigning additional traffic to Queue 4 may interfere with
stack control.
Use Defaults—Uses the device defaults for mapping CoS values to a forwarding queue.
l
Mapping a CoS value to a Queue:
1. Open the CoS to Queue page.
2. Select a CoS entry.
3. Define the queue number in the Queue field.
4. Click Apply Changes. The CoS value is mapped to a queue, and the device is updated.
Assigning CoS Values to Queues Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the Mapping CoS Values to Queues Table.
CLI Command
wrr-queue cos-map queue-id cos1.cosn Maps assigned CoS values to the egress queues.
Description
Advertisement
Table of Contents
