Add A Static IP Interface Page
3. Define the IP Address, Interface, Network Mask, or the Prefix Length fields.
4. Select the interface to which the IP interface will be assigned.
5. Click Apply Changes. The new interface is added, and the device is updated.
Displaying the IP Interface Table:
1. Open the IP Interface Parameters page.
2. Click Show All. The IP Interface Table page opens. The IP Interface Table contains the same fields as the
IP Interface Table Page
Deleting IP addresses:
1. Open the IP Interface page.
2. Click Show All. The IP Interface Table page opens.
3. Select an entry in the IP Interface Table.
4. Check the Remove check box to remove IP addresses.
5. Click Apply Changes. The IP address is deleted, and the device is updated.
Defining IP Interfaces Using CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the IP Interface Parameters page.
CLI Command
ip address ip-address {mask | prefix-length}
no ip address [ip-address]
show ip interface [ethernet interface-number | vlan vlan-id | port-channel number]
The following is an example of the CLI commands:
Console (config)# interface vlan 1
"Defining IP
Description
Sets an IP address.
Removes an IP address
Displays the usability status of interfaces configured for IP.
Interfaces".