Adding a static ARP Table entry:
1. Open the ARP Settings page.
2. Click Add. The Add ARP Entry page opens.
Add ARP Entry Page
3. Select an Interface and define its IP Address and MAC address fields.
4. Click Apply Changes. The ARP Table entry is added, and the device is updated.
Displaying the ARP Table:
1. Open the ARP Setting page.
2. Click Show All. The ARP Table page opens.
ARP Table Page
Deleting ARP Table entry:
1. Open the ARP Setting page.
2. Click Show All. The ARP Table page opens.
3. Select a table entry.
4. Check the Remove check box
5. Click Apply Changes. The ARP Table entry is deleted, and the device is updated.
Configuring ARP Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed in the ARP Settings page.
CLI Command
arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel number} Adds a permanent entry in the ARP cache.
arp timeout seconds
show arp
no arp
The following is an example of the CLI commands:
Description
Configures how long an entry remains in the ARP cache.
Displays entries in the ARP Table.
Removes an ARP entry from the ARP Table.