Table of Contents
Advertisement
Unit Active image Selected for next boot
-----------------------------------------------------
1 image-2 image-2
2 image-1 image-1
Both the active Image file and the Image file that is active after the device is reset are displayed for all units.
4. Enter console# copy tftp://{tftp address}/{file name} image to copy the software to the Master unit. The file is copied, but does not become active
until the file is selected as the Active Image file after the device is reset. The following is an example of the information that displays:
console# copy tftp://176.215.31.3/332448-10018.dos image
Erasing file image-1...done.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Copy: 2739187 bytes copied in 00:01:13 [hh:mm:ss]
5. Enter console# boot system image-1 to set the Image file that is used after the device is reset.
6. Enter console# reload. The following message displays:
This command will reset the whole system and disconnect your current
session. Do you want to continue (y/n) [n] ?
7. Enter Y. The device reboots.
8. Repeat step 3 to verify which Image files are active.
9. Enter console# copy image unit://2/image. The following is an example of the information which displays:
console# copy image unit://2/image
...................Unit 2: Erased image-2
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!
Copy: 2883576 bytes copied in 00:01:35 [hh:mm:ss]
console# 01-Jan-2000 01:08:59 %COPY-W-TRAP: The copy operation was completed successfully
10. Enter console# boot system unit {unit number} image-{file name}.
11. Repeat step 9 for each Stacking unit.
12. Enter console# reload. The following message displays:
Advertisement
Table of Contents
