Banking The Output Section; Selecting And Targeting Channels - DigiDesign VENUE Profile Manual

Banking the Output Section

Outputs are controlled using the Output faders and Encoders.
The Mains fader provides constant access to the house output
(Mains) bus, and does not follow Output fader banking.
To bank the Output faders to control Auxes, PQs, Matrix mixers,
Groups (or Var Groups), or VCAs:
Press the corresponding switch in the Output Faders sec-
tion.
Select
Output
banks
Bank switches for Output channels

Selecting and Targeting Channels

Each VENUE channel strip has a channel Select switch. The
Select switch targets that channel for routing or processing as-
signment. When a single channel is selected it becomes the
targeted channel, which can be adjusted from the console or
on-screen. Channels can also be selected by clicking their
fader strips on-screen.
To select a channel, do one of the following:
Press the Select switch on the console channel strip.
– or –
Click anywhere in the on-screen channel fader strip, except
on the fader, mute, solo or safe buttons.
Click to select channel
Clicking on-screen to select a channel
46 VENUE Profile Guide
Multi-Select (Shift)
Multi-Select lets you select multiple channels in order to apply
an action to them in one step.
To select multiple channels from the console:
Press and hold the Multi-Select switch (located next to the
1
input Bank switches). The switch flashes to indicate Multi–Se-
lect mode.
Press Select on each channel you want to include in the se-
2
lection.
Release the Multi-Select switch.
3
Perform a routing assignment or other function (for exam-
4
ple, press a Bus Assign switch on one of the included chan-
nels). The operation is applied to all selected channels.
You can use the Shift key on the keyboard or the Multi-Se-
lect (Shift) switch to select multiple channels.
To exit Multi-Select mode, do one of the following:
Press Cancel.
– or –
Press the Select switch on a channel that is currently not se-
lected.
To select multiple channels on-screen:
Press and hold the Multi-Select switch (or hold Shift on the
keyboard) and click the fader strips on-screen.
To select an 8-channel bank on-screen:
Click the bank name below the on-screen fader strips.
Shift-click to select additional banks or channels.
Clicking a bank display to select multiple channels on-screen
To select all input channels or all output channels on-screen:
Double-click any bank name below the on-screen fader
strips in the Input or Outputs screen.
To remove a channel from a selection:
Control-click (or Fine-click) a highlighted channel.
See "Screen Controls" on page 48 for additional on-screen
features.
Click to select
banks of 8