Routing Input Channels - DigiDesign VENUE Profile Manual

Routing Input Channels

Input channels and FX Returns can be routed to the Mains,
Groups/Var Groups, Auxes, Matrix mixers and PQ busses.
Routing Channels to the Mains and
Groups Busses
Input channels and FX Returns can be routed to the Mains
and Groups busses using the Bus Assigns section of the ACS.
To route one or more input channels to Mains and Groups busses
on the console:
Do either of the following:
1
• To select a single channel, press its Select switch.
• To select multiple channels, press Select on the first chan-
nel, hold the Multi-Select switch (located to the left of
the input faders), then press the Select switches on the
other channels.
To route to Mains, press the L–R (left and right) and/or
2
C/Mono (center/mono) switch in the Bus Assigns section so
that is lit.
– or –
To route to a Group bus, press a Groups 1–8 switch.
The L–R, C/M and 1–8 Bus Assign LEDs on each channel light
to indicate routing to the corresponding busses.
Mains
Groups
Bus Assign switches
To route channels to Mains or Groups on-screen:
Select one or more channels.
1
Go to the Inputs page.
2
Click the Bus Assign buttons to route to those busses.
3
For information on configuring the system Mains as L–R
plus Mono, or as L–C–R, see "Configuring Aux, Group, and
Variable Group Busses" on page 78. For more information
on configuring Group busses, see "Configuring Aux, Group,
and Variable Group Busses" on page 78.
Stereo Pan
Routing Channels to Aux Sends
Input channels and FX Returns can be routed to Aux sends us-
ing the input encoders, using the ACS, or on-screen.
To route channels to Aux sends using the input encoders:
Press an Encoder assign Send switch 1–2 through 15–16.
1
• The first press of an Aux Send switch assigns level control
of the odd-numbered send to the encoders. The switch
lights green to indicate an odd-numbered selection.
• The second press of an Aux Send switch assigns level con-
trol of the even-numbered send to the encoders. The
switch lights yellow to indicate an even-numbered selec-
tion.
Aux
Sends
Encoder assignment switches for input channels
For each channel you want to assign to the selected Aux
2
Send bus, press its channel encoder so that its "On" indicator
LED lights.
To set the Aux Send level, do either of the following:
3
• Turn the encoder on each channel.
• Press the Flip to Faders switch, then adjust the channel
fader.
To route channels to Aux Sends busses using the ACS:
Do either of the following:
1
• To select a single channel, press its Select switch.
• To select multiple channels, press Select on the first chan-
nel, hold the Multi-Select switch (located to the left of
the input faders), then press the Select switches on the
other channels.
In the Aux Sends section, press the Aux 1–8 or 9–16 switch
2
to bank it to the corresponding pairs of Aux Sends.
Press an Aux Sends encoder to enable that send.
3
Rotate the encoder to adjust that send level.
4
Chapter 7: Inputs and Input Routing 69
Encoders