DigiDesign VENUE Profile Manual page 70

Aux Mon and Aux FX
These settings let you classify individual Aux Sends (including
linked bus pairs) as monitor sends ("Mon") or as effects sends
("FX"), which lets you scope each type separately from the
Snapshots page.
This option is for organizing Aux Sends and Var Group Sends
for snapshot control only, and does not directly affect Aux bus
operation.
MTC (MIDI Time Code)
The MIDI Time Code options let you control MTC operational
modes, frame rate, and Start Time.
Modes Available MTC modes are MTC Off, MTC Read (slave),
and MTC Generate (master).
Frame Rate This option sets the frame rate that is used when
generating MTC.
Start Time This option sets the start time that is used when
generating MTC.
MIDI
Designates the channel on which snapshots send or receive
MIDI Bank Select and Program Change information.
See Chapter 23, "Synchronization."
Snapshots Send on Channel This option sets snapshots to send
Bank Select and Program Change commands on a selected
MIDI channel. This provides a quick and easy way to send a
MIDI command every time a snapshot is fired, without having
to embed a MIDI program change within each snapshot.
Snapshot Send on Channel does not need to be turned on in
order to send other types of MIDI data that are embedded in
snapshots, such as note on/off or MMC.
Snapshots Respond to Channel This option sets snapshots to
respond to incoming Bank Select and Program Change com-
mands on the selected MIDI channel.
MIDI Snapshot Output Safe Safes (shuts off) VENUE MIDI out-
put when snapshots are recalled. This does not affect sending
of Bank Select and Program Change commands with the Snap-
shots Send on Channel option.
60 VENUE Profile Guide
Misc
The Miscellaneous page provides utility and other settings.
Misc tab of the Options page
Oscillator
Lets you choose the tone, frequency, and level for the built-in
oscillator, and route it to an available output.
Signal Lets you choose the type of oscillator tone to use.
Choices include sine, variable sine, and noise.
Frequency Lets you set the oscillator frequency.
Route Enables Route Osc to Selected mode, to assign the oscil-
lator signal to the currently selected output channel(s).
2-Track
Lets you set the level and input source for the 2-Track analog
and digital inputs, and route them to the desired outputs.
2-Track Level Lets you activate 2-Track input and set 2-Track
input level.
2-Track Input Selects which 2-Track input (analog, or digital) is
fed to the monitors and output busses.
Route Enables Route 2-Track to Selected mode, to assign the
2-Track signal to the currently selected output channel(s).
Talkback
Talkback Level Lets you activate Talkback and set Talkback in-
put level.
Talkback Dim Level Sets the dim level, which is the amount of
attenuation applied to the mix on the output bus when Talk-
back is activated.
Route Enables Route Talkback to Selected mode, to assign the
Talkback signal to the currently selected output channel(s).