Routing The Oscillator - DigiDesign VENUE Profile Manual

Routing the Oscillator

The output of the internal oscillator can be routed to Input
Channels, FX Returns, or any of the output busses. The Oscil-
lator provides selectable signal type, frequency (for Variable
Sine) and signal level, as well as a master on/off switch.
Configuring the Oscillator and Setting Level
To activate and set the level for the oscillator:
Go to the Options > Misc page.
1
As a precaution, click and drag the on-screen Level encoder
2
down to set Oscillator level to off before you proceed.
Oscillator controls in the Options > Misc page
In the Oscillator section, click the Signal pop-up and select
3
from the following signal types:
• 100 Hz Sine
• 1 kHz Sine
• 10 kHz Sine
• Variable Sine
• Pink Noise
• White Noise
If you select Variable Sine, you can set the sine wave fre-
4
quency with the on-screen frequency control (directly to the
right of the Signal pop-up).
Click the on-screen In button in the Oscillator section.
5
Set oscillator level by slowly raising the on-screen Level en-
6
coder.
126 VENUE Profile Guide
To assign the Oscillator signal to an output bus:
In the Options > Misc page, click the Route button in the Os-
1
cillator section.
Do either of the following:
2
• If you had already selected the desired output, click to
confirm the currently displayed Route To mode (in the
lower left corner of the screen).
– or –
• Go to the Outputs page and click to select an output (it
flashes briefly).
In the confirmation dialog that appears, click Route to con-
3
firm your assignment or click Cancel to cancel without chang-
ing the current routing.
Signals are routed to output busses post-mute and post
fader.
Talkback, 2-Track and Oscillator States When
Loading Shows
When you load a Show file, Talkback, 2-Track and Oscillator
controls are set to off (deactivated), regardless of their state
when the Show was last saved.