Routing Aux Busses To Outputs And Plug-Ins - DigiDesign VENUE Profile Manual

To route channels to Aux Sends busses using the ACS:
Do either of the following:
1
• To select a single channel, press its Select switch.
• To select multiple channels, press Select on the first chan-
nel, hold the Multi-Select switch (located to the left of
the input faders), then press the Select switches on the
other channels.
In the Aux Sends section, press the Aux 1–8 or 9–16 switch
2
to bank it to the corresponding paris of Aux Sends.
Press an Aux Sends encoder to enable that send.
3
Rotate the encoder to adjust that send level.
4
To route channels to Aux Sends from the Output section:
Press the Auxes 1–8 or 9–16 switch to bank the Output fad-
1
ers to those Aux busses.
Press the Select switch in the Output strip for the Aux Send
2
to which you want to assign channels.
Press the Multi-Assign switch near the Output encoders. The
3
Multi Assign and output Select switches flash.
Press the Select switch on the channels you want routed to
4
the selected Aux Send.
Press the Multi Assign switch again to confirm the action.
5
– or –
Select another Aux Send to confirm the current assignment
but remain in Multi Assign mode to assign channels to the
newly targeted Aux bus.
Routing Aux Busses to Outputs and
Plug-Ins
Aux and Var Group busses can be routed to hardware outputs
and to available bus-fed plug-ins.
To route an Aux or Variable Group output to the Main busses from
the ACS:
Press an Auxes switch (1-8 or 9-16) in the Output section to
1
assign control of Aux levels to the Output faders.
Select each Aux that you want to assign to the Main busses
2
by pressing their Select switches.
In the ACS Bus Assigns section, press the L–R (left and right)
3
or C/Mono (center/mono) switch so that it is lit.
Move the channel's fader to set the Aux output level.
4
Like other Output busses, Aux busses also provide Direct Outs,
inserts and built-in Graphic EQ capabilities. For details, see the
following:
Direct Outs See "Direct Outputs" on page 83.
Inserts See "Using Inserts on Output Busses" on page 80.
Graphic EQ See "Inserting the Built-In Graphic EQs on Output
Busses" on page 81.
Chapter 10: Aux Sends and Variable Groups 95