Devices; Other Options And Settings - DigiDesign VENUE Profile Manual

To change the Aux/Group Bus Configuration:
Put the system in Config mode.
1
Click the Edit button on-screen.
2
Click to select a Bus Configuration option.
3
Click Apply; the system restarts.
4

Devices

The Devices page lets you view system connections, trouble-
shoot hardware and reset VENUE system components.
To display the Devices tab:
Click Options > Devices.
Devices tab of the Options page
You can use this page to view component status after diagnos-
tics or troubleshooting.
To reset VENUE system hardware components:
Put the system in Config mode.
1
Go to the Options page and click the Devices tab.
2
Right-click any of the following hardware components:
3
• Console sections
• Racks (Mix Rack, FOH Rack or Stage Rack)
Choose Reset.
4
Simulating a VENUE Configuration with the
Standalone Software
With the VENUE D-Show Standalone software, you can use
the Devices page to simulate a VENUE system of any size for
purposes of preparing shows and training. See "Simulating a
VENUE Configuration" on page 218.

Other Options and Settings

Busses
The Busses page lets you customize characteristics for the Aux,
Solo, Matrix, and Main busses.
Busses tab of the Options page
Auxiliaries and Variable Groups
These options let you designate bus link status, pick off source,
and stereo pan behavior for Auxiliaries (Aux Send busses).
Links When enabled, this option links the corresponding bus-
ses into bus pairs. Control changes affect both mono Aux bus-
ses, and the Follows Channel Pan option becomes available.
Pickoff These options let you designate the pre-fader pickoff
point feeding each bus. Choices include pre-EQ, pre-mute,
and pre-fader (post-mute).
Follows Channel Pan Each channel can be panned indepen-
dently within each linked bus pair, or configured to follow the
channel pan by enabling the Follows Channel Pan option.
To change the Aux bus configuration:
Put the system in Config mode.
1
Go to the Options page and click the Busses tab.
2
Click Edit.
3
Configure the following settings:
4
• To link two mono Aux busses into a bus pair, select the
Link option for the corresponding pair.
• Specify the panning for channels routed to Aux bus pairs
with the Follows Channel Pan option.
• Click to select the pickoff point for each bus (Pre-EQ,
Pre-Mute, or Pre-Fader).
Chapter 6: Options 57