DigiDesign VENUE Profile Manual page 132

You can apply an adjustable delay to the monitor outputs and
headphone outputs to match the acoustic delay from the
main speaker system.
To adjust monitor output delay:
Go to the Options > Busses tab.
1
Adjust the Delay setting in the Solo and Monitor Operations
2
section. Be sure to click the In button beneath the on-screen
encoder to enable Delay. When lit, the Delay setting is applied
to the monitor output.
Cue on Mains Fader
The Mains fader can be assigned to control cue (Monitor bus)
output level. Enabling the Cue on Mains Fader option lets you
adjust solo PFL/AFL level without having to take your hands
off the faders.
Control of the Mains busses remains available from the Out-
put encoders and on-screen in the Outputs page.
The Cue on Mains Fader setting is stored with the Show file.
To enable Cue on Mains:
Turn the Monitoring encoder fully counter-clockwise (off).
1
Go to the Options > Busses page.
2
Under Solo and Monitor Operations, select the Cue on Mains
3
Fader option.
Cue on Mains
The Mains fader now controls Monitoring level. The Mains Se-
lect switch flashes quickly.
To exit Cue on Mains (return to normal):
Go to the Options > Busses page, then click to deselect the
Cue on Mains option.
You can set up an Event to toggle Cue on Mains on or off.
See Chapter 22, "Events."
While Cue on Mains is enabled, the Mains busses remain
available on-screen, and can be targeted to the ACS.
122 VENUE Profile Guide
Adjusting the Mains While Cue On Mains Fader is
Enabled
When Cue on Mains Fader is enabled, the Mains output level
remains at its last setting and remains accessible from the con-
sole and on-screen, as follows:
Adjusting Mains with the Output Encoders
Enabling Cue on Mains Fader puts Mains control on Output en-
coders 1—3.
Bus control while Cue on Mains is enabled
While Cue on Mains Fader is active:
• Enabling Insert mode replaces the current Output en-
coder assignments with insert controls.
• Banking to Matrix or PQ replaces the current Output en-
coder assignments with the sources for the selected Ma-
trix or PQ.
Adjusting Mains On-Screen
You can use the controls in the Outputs page on-screen to se-
lect, mute, or adjust the level of any of the Mains busses (L, R
and C/Mono).
Select a Mains bus on-screen to target it in the ACS, then use
Cue on Mains
the selected channel controls to select, mute, or adjust the
level of the Mains busses.
On VENUE D-Show systems, Mains bus linking/unlinking
and Safe controls are only available on-screen while Cue on
Mains Fader is enabled.
Mains
L R C/M (or L C R)
Cue
(Monitoring)