D Contest Number Set Mode - Icom IC-7700 Instruction Manual

4
RECEIVE AND TRANSMIT

D Contest number set mode

∫ √
F-1 F-2
• Contest number set mode screen
Number Style
This item sets the numbering system used for con-
test (serial) numbers— normal or short morse num-
bers.
Short morse numbers are also referred to as "cut"
numbers.
Count Up Trigger
This selects which of the four memories will contain
the contest serial number exchange. The count-up
trigger allows the serial number to automatically
increment after each complete serial number ex-
change is sent.
Present Number
This item shows the current number for the count-up
trigger channel set above.
Main dial
EXIT/SET
DEF
F-4
This menu is used to set the contest (serial) number
and count-up trigger, etc.
• Setting contents
q During CW mode operation, push [KEYER]
to select memory keyer screen.
w Push
EXIT/SET
push [001] F-3
set mode.
e Push [Y]
F-1
set item.
r Set the desired condition using the main dial.
• Push and hold [DEF]
fault condition or value.
t Push
EXIT/SET
Normal
• Normal : Does not use short morse numbers
(default)
• 190➔ANO : Sets 1 as A, 9 as N and 0 as O.
• 190➔ANT : Sets 1 as A, 9 as N and 0 as T.
• 90➔ NO : Sets 9 as N and 0 as O.
• 90➔ NT : Sets 9 as N and 0 as T.
M2
• M1, M2, M3 and M4 can be set. (default: M2)
001
• Rotate the main dial to change the number, or push
and hold [001CLR]
rent number to 001.
4-10
to select memory keyer menu, then
to select contest serial number
or [Z] to select the desired
F-2
for 1 sec. to select the de-
F-4
twice to normal screen.
F-4 for 1 sec. to reset the cur-
F-3