D Programming The User Band Edge - Icom IC-7700 Instruction Manual

3
BASIC OPERATIONS

D Programming the user band edge

Appears when "ON (User)" or "ON (User) & TX Limit" is
selected.
• Band edge screen
q Select the Others set mode and select the "Beep
(Band Edge)" option.
w Rotate the main dial to select either the "ON (User)"
or "ON (User) & TX Limit" setting.
• [BAND] appears above
e Push [BAND]
F-5
r Push [Y]
F-1
band edge.
• Push [t u]
F-3
edge frequency entry cell.
• Push [INS] (MF6) to insert a new blank band edge line.
• Push and hold [DEL] (MF7) for 1 sec. to delete the se-
lected band edge line.
t Push F-INP ENT
quency with the keypad.
• Push • to input decimal point (".") between the
GENE
MHz and kHz digits.
• Program each channel from left to right and each fre-
quency must be higher than the preceding frequency.
• The frequency that is duplicated, or out of an amateur
band, cannot be programmed.
• If you want to return the band edge frequencies to their
default (initial) value, push and hold [DEF]
1 sec.
The band edge initialize screen appears as shown
below, then push and hold [OK]
ize all band edge frequency settings.
y Push F-INP ENT
u Push
EXIT/SET
3-14
.
F-5
to open the band edge screen.
or [Z] to select the desired
F-2
to select the upper and lower band
, and then input the desired fre-
for 1 sec. to initial-
F-6
to set the input frequency.
to exit the set mode.
for
F-4