Installing The Video Display Driver - Intergraph RealiZm Graphics Z10 Hardware User's Manual

30

Installing the Video Display Driver

As an aid to troubleshooting, or should it become necessary to re-install the video display
driver, this section describes installing the Intergraph video display driver for Z13, Z25, and
V25. The system must be running Windows NT to install the video display driver.
NOTE The video display driver for Z13, Z25, and V25 is different from the vide o display driver for
Z10.
To install the video display driver:
1. Turn on system power and log on to the Windows NT operating system.
2. Open Display in the Windows NT Control Panel. The Display Properties dialog displays.
3. Select Settings. The Settings page displays.
4. Select Display Type. The Display Type dialog displays.
5. Select Change. The Change Display dialog displays.
6. Select Have Disk.
7. Insert the diskette containing the Intergraph video display driver into the floppy disk
drive; then, select OK.
8. At Change Display, select OK.
9. At the third-party driver warning, select YES.
10. At the Installing Driver dialog, select OK.
11. At the Display Type dialog, select Close.
12. If desired, configure the video display according to the system configuration and your
preferences. Refer to your system documentation, or select a setting and press
more information.
13. Select Apply at the bottom of the dialog to apply the attributes.
14. Remove the diskette from the floppy disk drive.
15. Restart the system.
, for
F1