Table of Contents
Advertisement
Chapter 2: Installing and Configuring an Agent
34
Screen
Time Zone
Date and Time
Root Password
Administrator
Password
Proventia Manager
Password
Bootloader
Settings Review
9. Select Finish, and then press
The Setup Complete screen appears.
10. Press the
key, select Yes to exit the Proventia Setup Assistant, and then press
ESC
.
ENTER
11. Disconnect your cables as follows:
If you are using...
terminal emulation
PXE bootserver for a
reinstallation (see
"Reinstalling an
Enterprise Scanner
Agent" on page 209)
12. Do one of the following:
If you want to configure explicit trust with your Agent Manager, go to
■
"Configuring Explicit-Trust Authentication with an Agent Manager" on page 35
If you want to continue setting up your appliance, go to "Registering Enterprise
■
Scanner to Connect to the SiteProtector System" on page 37.
Descriptions
The Time Zone for your appliance.
Tip: Press
to display the choices in the list, and then press
ENTER
the up and down arrows to select a choice.
The current Month, Day, Year, Hours, and Minutes for your
appliance.
Important: You must use a 24-hour time format.
Note: If the date and time are correct, you do not need to change
anything. You only need to change fields that are not already correct
in the Current System Date and Current System Time boxes.
The password required to log on to the operating system of your
appliance.
The password required to access the Proventia Setup Assistant on
the appliance.
The password required to access Proventia Manager through a Web
browser over a network connection.
Whether to require (Enable) or not require (Disable) the Bootloader
(root) password for backup and restore operations only.
Caution: If you enable the Bootloader password, you must use a
serial connection to the agent through a serial port and supply a
password to backup or restore the appliance; you do not need to be
connected for other operations.
A list of all the configuration settings you have chosen.
Tip: Press the
DOWN ARROW
and to see the Finish button.
.
ENTER
Then disconnect the following cables...
•
the RJ45 connection from the serial port on the back of the
computer
•
the RJ45 connection from the serial port on the back of the
computer
•
the red crossover cable from management port of the
appliance to the Ethernet port on the boot server computer.
•
and then press
CTRL
to see the complete list of settings
+
to eject the installation disk.
G
IBM Internet Security Systems
Advertisement
Table of Contents
