Defining Agent Passwords (Access Policy) - IBM Proventia Network Enterprise Scanner User Manual

Chapter 8: Defining Agent Policies

Defining Agent Passwords (Access Policy)

Introduction
Password
definitions
About the
bootloader
password
Procedure
114
Use the Access policy to change agent passwords and to enable (require) or disable the
bootloader password for backing up or restoring your agents.
You can change the passwords for the following accounts:
Account
root
Admin
Admin
Table 41: Agent password descriptions
The bootloader password provides additional security for your agent; however, you must
be connected to the agent with a serial connection and supply a password to back up or
restore the agent. You do not have to be connected with a serial connection for other agent
operations.
To change access to your appliance:
1. In the SiteProtector Console, set up a tab to display agent policies. (See page 74.)
2. On the navigation pane, open the Access policy for the agent.
The policy may be defined for only the agent, or it may be defined for a group
Note:
at a higher level than the agent.
3. For each password you want to change, do the following:
Type the current password in the Current Password box.
■
Click Enter Password, type the new password in the Password and in the Confirm
■
Password boxes, and then click OK.
4. If you want to require the use of the bootloader password to back up or restore the
agent, select the Enable bootloader password check box.
If you enable the Bootloader password, you must be connected to the agent
Caution:
with a serial connection and supply a password to back up or to restore the agent.
Purpose
To access the operating system of the appliance.
To access the Proventia Setup Assistant on the appliance if the
agent is not managed by a SiteProtector.
To access Proventia Manager through a Web browser over a
network connection.
IBM Internet Security Systems