Table of Contents
Advertisement
Publishing connector profiles
You can publish groups of connector profiles to one or more eCopy-enabled devices. You can
publish to eCopy ScanStation
software at the same time.
Publishing prerequisites
Following these rules helps ensure that a published group of connector profiles runs successfully
on the target devices:
The source device cannot be the same as any of the target devices.
■
The source device and the target devices must be in the same domain.
■
File paths that you specify during publishing must be valid on the target devices.
■
The version level of third-party client software, such as Lotus Notes, Microsoft Outlook,
■
™
and Captaris
On the target device, install only those connectors whose profiles you plan to select for
■
publishing from the source device. The Administration console will report successful
publishing for any connector profiles that are not installed on the target devices, but they
will be ignored on the target device.
Make sure that the Administration console is not running on the target devices. (If the
■
Administration console is running, an error message will appear in the status column.)
™
devices and to devices running eCopy ShareScan Embedded
™
RightFax
, must be the same on the source device and the target devices.
®
eCopy ShareScan
Installation and Setup Guide
|
181
Advertisement
Table of Contents
