Setting And Using Camera Presets - Polycom HDX Series User Manual

Setting and Using Camera Presets

© Polycom, Inc.
To adjust a camera using the remote control:
1. Press Near or
far-site control. During a multipoint call being hosted by a system in the
call, you can only adjust a camera at the far site that is currently speaking.
2. Press the arrow buttons on the remote control to move the camera up,
down, left, or right.
3. Press Zoom on the remote control to zoom out or in.
Camera presets are stored camera positions that you can create ahead of time
or during a call.
Presets allow you to:
• Automatically point a camera at pre-defined locations in a room.
• Select a video source such as a VCR or DVD player, a document camera,
or an auxiliary camera.
If your system's camera supports electronic pan, tilt, and zoom movement,
you can create up to 100 preset camera positions (0-99) for the near site. Each
preset stores the camera number, its zoom level, and the direction it points (if
appropriate). They remain in effect until you delete or change them.
If far-site camera control is allowed, you can create up to 16 presets (0-15) for
the far-site camera. These presets are saved only for the duration of the call.
You may also be able to use presets that were created at the far site to control
the far-site camera.
To move the camera to a preset:
1. If a call is connected, press
a near-site or far-site camera.
2. Press a number on the remote control.
To view your near-site presets:
Press Preset on the remote control.
Icons for presets 0-9 are shown on the screen. The colored icons indicate
stored camera positions, and the gray icons indicate available presets.
User's Guide for Polycom HDX Room Systems
Far to select either near-site or
Near or Far, then choose
9