Switching Between Full Screen Video And The Home Screen - Polycom HDX Series User Manual

User's Guide for Polycom HDX Room Systems

Switching Between Full Screen Video and the Home Screen

10
To store a preset:
1. If you are in a call, press
near-site or far-site camera or other video source.
2. If you selected a camera that supports electronic pan, tilt, and zoom, you
can adjust the camera's position:
— Press the arrow buttons on the remote control to move the camera up,
down, to the left, or to the right.
— Press Zoom to zoom the camera out or in.
3. Press Preset on the remote control.
4. Press and hold a number to store the preset position. To store a
double-digit preset, press the first digit quickly and hold the second
number down. Any existing preset stored at the number you enter is
replaced.
The system uses preset 0 as the default camera position.
To delete all presets:
1. If you are in a call, press
source.
2. Press Preset on the remote control.
3. Press and hold
You cannot delete just one preset. Instead, overwrite an existing preset with the
new camera position.
When the call connects, the system automatically shows video on the whole
screen. You can switch back to the home screen during a call if, for example,
you need to adjust a user setting, and your system is configured to allow you
to do so.
To see video in the full screen:
Press Near on the remote control.
To see the home screen:
Press Home on the remote control.
Near or
Near, then choose a near-site video
Delete to delete all presets.
Far, then choose a
© Polycom, Inc.