Setting And Using Camera Presets - Polycom QDX 6000 User Manual

User's Guide for Polycom QDX 6000 Systems
1
2
1
2
3

Setting and Using Camera Presets

6
You can adjust the far-site camera only if it is configured to allow you to control it.
To select a near-site or far-site camera, or other video source:
If you are in a call, press
select either near-site or far-site control.
Press Camera on the remote control. Then select the camera or
other video source you want to use.
To adjust a camera using the remote control:
Press Near or
Press the arrow buttons on the remote control to move the camera up,
down, left, or right.
Press Zoom on the remote control to zoom out or in.
Camera presets are stored camera positions that you can create ahead of time
or during a call.
Presets allow you to:
•
Automatically point a camera at pre-defined locations in a room.
•
Select a video source such as a VCR or DVD player, a document camera,
or an auxiliary camera.
If your system's camera supports electronic pan, tilt, and zoom movement,
you can create up to 100 preset camera positions (0-99) for the near site. Each
preset stores the camera number, its zoom level, and the direction it points (if
appropriate). They remain in effect until you delete or change them.
If far-site camera control is allowed, you can create up to 16 presets (0-15) for
the far-site camera. These presets are saved only for the duration of the call.
Near or
This onscreen icon indicates that you can control a
near-site camera or video source.
This onscreen icon indicates that you can control a far-site
camera or video source.
Far to select either near-site or far-site control.
Far on the remote control to
© Polycom, Inc.