Table of Contents
Advertisement
Installing the cutter
You need to install the cutter if you want the printer to automatically cut the
media after printing.
!
Be careful when handling the cutter to avoid injury.
!
Do not use an external knife to cut media as this can damage the
platen and prevent the media sensors from operating properly.
The exception to this is ribbed media which cannot be cut with the
cutter. It is OK to use scissors to cut ribbed media.
To install the cutter
1
Press the Access Cartridges button to move the carriage to the
left, out of the service station.
The cutter fits in the printer on the left side of the carriage. Install
the cutter by inserting it into the carriage.
2
Push the cutter into the slot until it clicks into place.
3
Press the Access Cartridges button to move the carriage back into
the service station. This ensures that the cutter blade is in the home
position.
1500 TX User's Guide
Getting Started 2-7
Advertisement
Table of Contents
