Table of Contents
Advertisement
1500 TX User's Guide
7
Place the suction end of the NovaPrime over the jet area of the cartridge.
8
Make sure the NovaPrime is making good contact with the jet area.
Pulse the pump 3 - 5 times, until the ink is visible in the NovaPrime sight
tube, maintain good contact between the inkjet plate and the pump for an
additional 5 seconds.
When removing the NovaPrime, use the silicone tip to wipe and clean the
jet plate. Remember to clean the silicone tip of ink before moving to the
next cartridge.
9
Check that there are no twists in the ink delivery line.
Check for ink on the jet plate. Continuous bleeding of the jet plate
indicates a loss of vacuum in the cartridge or an air leak in the lines.
Correct this before proceeding.
10 Insert the cartridge into the carriage.
11 Print the Prime pattern as described in the next section, then align the
cartridges as described later in this guide.
2-14 Getting Started
Advertisement
Table of Contents
