Table of Contents
Advertisement
1500 TX User's Guide
To remove the cutter
1
Press the Utility/Access Cartridges button to move the carriage to the
center of the platen.
2
Press the knife latch down.
3
Pull the cutter out of the carriage.
When the cutter becomes worn, it can cause the carriage to jam or can cause a
ragged media cut. In extreme cases, you might see an error message stating
"Carriage Axis Failure".
You can order replacement cutters from ENCAD by calling
800-45-ENCAD, (619-677-5071) or fax ENCAD at 619-549-7894. Users outside
the U.S. can call their local ENCAD sales center.
Filling the ink reservoirs
!
Use of inks other than ENCAD TX series ink may cause damage to
the printer.
The printer can support long, uninterrupted printing runs because each of its four
reservoirs holds 500ml of ink. The ink reservoirs are located at the printer's left
side.
Note: When running at carriage speeds faster than the default, it is recom-
mended that ink levels in the reservoirs be no more than 300ml maximum.
2-8 Getting Started
Advertisement
Table of Contents
