Table of Contents
Advertisement
Caring for your media
Store media in its original packaging in a cool, dry area until you are ready
to use it. The environment should be stable; i.e., no extremes of heat and
cold, and non-condensing humidity. If conditions are outside the operating
ranges recommended for the printer, allow the media to acclimate in the
operating environment for at least 48 hours before using it.
If you remove a roll of media from the printer, be sure to store it in a
manner which keeps it clean and dust-free. Ideally, you should return it to
its original packaging for storage.
Print on the correct side! Roll media is wound with the preferred side
out.
Handle with care! Handle your media carefully to avoid creases, scrapes,
and tears. Avoid crushing or damaging roll media edges.
Wear gloves! Photographic paper-based media is very susceptible to
scratching and creasing and may absorb skin oils. Fingerprints on
the media prior to printing may result in visible fingerprints after ink
is applied.
Choose the correct printing mode
There are four modes of printing, giving you freedom to tradeoff printing
quality and speed. Normal and draft modes can be used for most fabric
designs. If banding occurs, use Quality or Enhanced mode. Be sure to use
Enhanced mode when printing on Photogloss media.
1500 TX User's Guide
Introduction 1-5
Advertisement
Table of Contents
