Table of Contents
Advertisement
1500 TX User's Guide
Using the power media feed and take-up system
The power media feed and take-up system facilitates long, unattended printing
runs by automatically unwinding and rewinding media as prints are generated. It
includes a feed roll, a take-up roll, and sensors which prevents media from coming
into contact with the floor.
When the unit is first turned on, the feeder may turn for a few seconds. If the
take-up turns, the sensor is blocked. Clear anything blocking the sensor before
proceeding.
To load roll media
1
Slide the rolled media onto the media (upper) roller, orienting it as shown
below. Slide the media guide into the roll core, and tighten the guide to
secure the roll by turning the blue knob clockwise. Standing behind the
printer, insert the media's leading edge into the back of the printer,
aligning the paper edge with the alignment mark on the platen. The
printer will sense the presence of the media and automatically feed it.
2
As printing progresses, media is looped down in front of the take-up core
until it is detected by the sensor on the printer stand leg. The take-up rolls
then activate to roll the media.
Be sure not to block the sensor!
3
Press Load Media to move the media into printing position.
2-4 Getting Started
Advertisement
Table of Contents
