Table of Contents
Advertisement
Cartridges leaking
Check that reservoirs are not overfilled.
Various nozzles are clogged or stop firing
Repeat prime several times.
Remove, clean, and reinstall cartridge; repeat prime. Do not use alcohol on
the jet area.
Clean service station; clean cartridge again; repeat prime.
Clean cartridge electrical contacts using a cotton swab moistened with
water. Dry contact. Repeat prime. Do not use acetone or any other harsh
cleaner as this may cause damage to the flex cable.
Nozzle may have failed. Replace cartridge. Check for nozzle clogs by
using the suction bulb on the cartridge nozzle plate.
Check to see whether spray from printing has contaminated the flex
contact. Remove the cartridge and wipe the carrier flex and cartridge flex
with a cotton swab dipped in alcohol.
Run prime. If sections of the print are missing, replace the cartridge.
Ink spills on the flex cable
Clean the flex cable gently with a cotton swab moistened with water. Do
not use acetone or any other harsh cleaner as this may cause damage to
the flex cable.
Printer settings are lost when printer is turned off or rebooted
Be sure to save your printer settings to a User number. (See "Saving
User Settings" in Chapter 3.) When you are ready to print, select the
User number that you saved.
What if I need a firmware upgrade?
You can download firmware upgrades from ENCAD's BBS or from the
Internet WEB page.
1500 TX User's Guide
Troubleshooting I-7
Advertisement
Table of Contents
