Replacing The Reservoirs; Installing New Cartridges - Kodak 210433-1 User Manual

Replacing the reservoirs

1 Remove all the cartridges before replacing the ink reservoirs.
2 Open the left front cover to access the reservoirs. Leave the caps on the
reservoirs. Disconnect the quick connect fitting for each reservoir, noting
the color of the fitting to which it was connected.
3 Slide each reservoir forward to remove it from the printer.
Store the reservoirs away from direct sunlight in an environment similar to
that of the printer.
4 Replace the reservoirs with new reservoirs.
5 Fill the reservoirs with ink and attach to the quick connect fittings not used
for the previous type of ink.

Installing new cartridges

Be sure the cartridges you are installing contain the same type of ink as
the reservoirs. Fill them, if necessary, snap them into place and attach the
quick connect fittings as described in Chapter 2.
!
The printer will only operate when TX cartridges are in-
stalled. Installing non-TX series cartridges may damage the
printer and will prevent it from operating correctly.
!
Don't attempt to install or remove an ink cartridge from the
carriage at any time without first selecting Utility/Access
Cartridges to move the carriage away from the service
station. Don't attempt to manually pull the carriage out of
the service station while the printer is turned on. This can
damage the printer.
!
Touching the copper area that houses the electrical intercon-
nect and the inkjets can damage the cartridge.
4-4 Printer maintenance and storage
1500 TX User's Guide