Installing The Power Cable - Leica iNEX User Manual

2.3

Installing the Power Cable

The Power Cable should be connected to a clean 12-volt power system;
however the iNEX will operate between 9 and 16 volts DC and as such will
tolerate normal fluctuations found in a typical vehicle power system.
1. Connect the red wire to a 12-volt positive source.
2. Connect the black wire to the vehicle's earth.
3. Route the cable into the cab where the iNEX Vehicle Cable will be
installed.
Note: The iNEX is a 12-volt DC (negative-to-earth) system only. Connecting to a 24-volt
DC or a positive-to-earth system will cause damage which is not covered by warranty.
Do not connect the power cable to only one battery of a 24-volt system as this may
cause damage to the vehicle's batteries and connected equipment.
There are a number of other power cable options available, including a
three wire power cable which can be connected to the vehicle ignition to
turn the iNEX on and off with the vehicle's ignition key.
Also available are power cables terminated with common connections
found in agricultural vehicles, such as the universal three pin circular
connector and the John Deere power strip connector.
For more information on any of these cables, contact your point of
purchase.
iNEX User Manual
Page 7 Rev 2