Connecting The Optional As310 - Leica iNEX User Manual

2.7

Connecting the Optional AS310

The AS310 is required for some installations where automatic section
shut-off is being used. The AS310 converts signals from the iNEX to
output signals which can then be connected to 3rd party rate controllers
and other section control equipment.
1. Mount the AS310 in a suitable out of the
way location.
2. Connect Port C on the iNEX Vehicle Cable
to the Data Port on the AS310. The
connectors may need to be twisted until
the locating tabs in the connectors align.
Push the connectors firmly together
while twisting the locking ring.
3. Connect the required automatic section
control cable to the voltage port on the AS310, using the same
twisting action.
iNEX User Manual
Page 10 Rev 2