Leica iNEX User Manual page 66

6.4.2 Creating a New Product
Products are split into the three different categories Chemicals, Fertilisers
and Seed. The information required for each of these is slightly different
but the principal for entering any new product is the same. New products
can be added on the go when filling the tank, creating batch records or in
the office using PlanIT.
1. Follow the steps in 6.4.1 Recording
Products Applied or 6.4.3 Adding a
Product Batch to reach the Select
Product screen.
2. Select the type of product by pressing
the appropriate tab.
3. Press NEW.
4. To set any required value press on the
appropriate button.
The minimum that must be entered
for a product is Product Name, Variety
(if seed product), Units and Units in
Tank.
The Units value refers to the units the
product is normally purchased in.
The Units in Tank value refers to the
units that are normally used to describe the application rate of the
product.
5. Press
ACCEPT
iNEX User Manual
when all required values have been entered.
Page 59 Rev 2