Leica iNEX User Manual page 61

6.3.1 Creating Boundaries
Before AutoFIELD can recognise the field, a farm map containing the field
boundaries must be created. The farm map can be created in the office
using PlanIT or on the go in the iNEX.
Boundaries can be created on the go when using the iNEX by simply
ensuring a complete first lap has been driven around the boundary of the
field before treating the rest of the field. When the field is archived, if it
has not been done inside a recognised boundary, the iNEX will ask if a
boundary is to be created.
1. Start a new field (see 3.6.2 Starting A New Field).
2. An outside perimeter will automatically be
created when a treatment is recorded and the
end point is within twice the vehicle swath width
(or 20 metres, whichever is greater) of the start
point. To ensure corners of the boundary do
not get cut off it is best to start part way along
a straight boundary edge.
3. Drive a complete lap of the boundary with
treatment recording ON. Note that the
boundary area will automatically close when
returning to within 2 times the vehicle swath
width from the starting point.
4. When the boundary lap has been
completed, check the total area on the
AREA Status Bar (see 7.4.5 Select Status
Bar Details) is the approximate area of
the field.
iNEX User Manual
Page 54 Rev 2