Installing The Inex Vehicle Cable - Leica iNEX User Manual

2.4

Installing the iNEX Vehicle Cable

1. Connect the Display connector on the vehicle cable to the iNEX
Display. The connectors may need to be twisted until the locating
tabs in the connectors align. Push the connectors firmly together
while twisting the locking ring.
2. After the power cable has been connected to a clean 12-volt source,
it can be connected to the Power input connector using the same
twisting action. When the power connection is made to the iNEX
Display, it will emit two short beeps to indicate it is powered.
3. If using serial NMEA GPS or a mojoRTK, connect the device to Port B
(yellow cable) on the vehicle cable, using the appropriate serial
cable.
4. If using a CANbus NMEA2000 GPS, connect the device to the CANbus
port (white cable).
5. Where required, connect any supported 3rd party rate controller to
Port A (blue cable), using the appropriate serial cable.
6. If using a GPSteer auto steer controller, then it should be connected
to Port A if not being used by a rate controller, and Port B if Port A
is used while Port B is free. Alternatively where both Port A & Port
B are used, a USB to Serial converter cable can be obtained from
your point of purchase.
Note: If you are unsure which cable should be used to connect another device, contact
your point of purchase.
iNEX User Manual
Page 8 Rev 2