NEC N8100-1573F User Manual page 373

7.
Select the [Intel(R) ICH9R/DO/DH SATA AHCI Controller] and press Enter.
The screen of Step 5 is displayed.
– If the N8103-109/116/117 is used:
Press S.
The screen of Step 6 is displayed. Press Enter, and go to Step 8.
– If the N8103-109/116/117 is not used:
Press Enter, and go to Step 9.
8.
Select the proper RAID Controller and press Enter.
– [LSI Embedded MegaRAID (Windows XP/2003)]
(When Onboard RAID Controller(LSI Embbede MegaRAID) is used.)
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-116/117 RAID Controller is installed.)
– [Promise SuperTrak EX SAS RAID Controller - 32bits platform]
(When N8103-109 RAID Controller is installed.)
The screen of Step 5 is displayed.
Press Enter, and go to Step 9.
9.
When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT:
larger than 2,097,152MB(2TB), you can specify only a value equal to
or less than 2,097,152MB as partition size.
10.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
If you install Windows Server 2003 on the hard disk
Installing Windows Server 2003 F-9