Table of Contents
Advertisement
4-38 Configuring Your Server
7.
Press F10 to create virtual drive.
The [Virtual Drives Configure] screen appears. (The figure below shows an example of
RAID1 configured with two hard disk drives.)
8.
Select "RAID", "Size", "DWC", "RA", or "Span" by using cursor keys. Then press Enter
to fix the selection and set each value.
(1) "RAID": Sets RAID level.
Parameter
0
1
The selectable RAID level varies depending on the number of hard disk drives
that configure a pack.
(2) "Size": Sets virtual drive size.
Specify the capacity of virtual drive. Up to 8 virtual drives can be created with
Onboard RAID Controller.
(3) "DWC": Sets parameter for Disk Write Cache.
Parameter
Off
On *
*1 Recommended setting.
(4) "RA": Sets parameter for Read Ahead.
Parameter
Off
On
Remarks
RAID0
RAID1
Remarks
Write through
1
Write back
"Write-back On" enables good performance, however, cache data may be lost at
an unexpected power failure. "Write-back Off" reduces performance by
approximately 50%.
Remarks
Does not perform read ahead.
Performs read ahead.
Advertisement
Table of Contents
Troubleshooting
