NEC N8100-1573F User Manual page 291

Connecting with N8103-116/117 RAID Controller
Install N8103-116/117 RAID Controller in the following procedure:
3.5-inch Disk Model
Take the following steps to connect the cable.
1.
Install the RAID Controller on the PCI riser card.
2.
Remove the hard disk drive bay.
3.
Remove the two power connectors of SATA cable from the server chassis.
4.
Remove the two SATA connectors from the mother board.
5.
Remove the four screws from the SATA cable connectors.
Power connector
SATA cable
Upgrading Your Server 9-35