NEC N8100-1573F User Manual page 245

The PXE boot (network boot) fails or the server is not found on the network:
Is the cable connected properly?
Connect the proper cable to the network port on the rear of the Express server. In
→
addition, make sure that the used cable conforms to the network interface standard.
Is BIOS configuration correct?
The internal LAN controller may be disabled with the BIOS SETUP utility of the
→
server. Check the setting with the BIOS setup utility.
Have the protocol and service already configured?
Install the distinctive network driver for the server. Make sure that the protocol,
→
such as TCP/IP, and services are properly specified.
Is the transfer speed correct?
Open the network property dialog box in control panel to specify the link speed
→
and duplex value the same as the value specified for HUB.
The Telnet Service is not installed.
Adjust the computer name to 14 characters or less, and then install the Telnet
→
Service according to <How to install the Telnet Service>.
<How to install the Telnet Service>
1.
Click [Run] on Start menu.
2.
Type "tlntsvr /service" in the [Open] box, and click [OK].
3.
Click Start menu, point to [Control Panel] and click [Computer Management] and then
click the [Services] to specify whether the Telnet Service is registered.
* When the installation of Telnet Service is finished, there is no problem if the
computer name is set to 15 characters or more.
Fail to start the OS with the /3GB switch
System often fails to start the OS with the /3GB switch.
→
In this case, please adjust the capacity of the user mode area using the /userva
switch in reference to the following URL.
http://support.microsoft.com/kb/316739/en
The system time lags:
If you do not use the server that adjust time such as NTP (Network Time Protocol)
→
Server, the system time may differ from actual time.
In this case, use NTP server or disable "Windows Time Service".
Troubleshooting 8-23