NEC N8100-1573F User Manual page 275

Notes
Observe the following notes on installing/removing a PCI board:
Do not touch the terminals of the PCI board and PCI riser card and the leads of electronic
components with your bare hand. Fingerprints and dust left on them cause the server to
malfunction due to a connection failure or damage to the leads.
A riser card is designed for installing only low-profile PCI board. Before installing a PCI
board, make sure of the card specification.
Set "Disabled" for the option ROM of a LAN device not to be booted by using the BIOS
SETUP utility.
If an additional LAN device is installed, it is hard to push the catch of the connector with
your finger that is connected to the LAN port. Disconnect the connector pushing the catch
with a standard screwdriver. At this time, be very careful for the screwdriver not to
damage the LAN port or other ports.
If a bootable LAN card is additionally installed, the boot priority may be changed. After
the additional installation, run the BIOS SETUP utility, select [Boot] and set the new boot
priority.
See the table below for available boards and slots.
N Code
N8103-109
N8103-116
N8103-117
N8103-104A
N8104-126
N8104-122
N8104-125
√: Available, –: Unavailable
*1 Optional riser card N8116-20 (PCI Express) must be installed to use the PCI slot.
*2 Depth of PCI board available for slot:
Board of low-profile type: Depth 167.6 mm max., width 64.4 mm max.
*3 To install a 2.5-inch SAS hard disk drive, you need to install RAID Controller (N8103-
109, N8103-116/117).
Product Name
*3
RAID Controller (128MB, RAID 0/1/5/6)
*3
RAID Controller (128MB, RAID 0/1)
*3
RAID Controller (128MB, RAID 0/1/5/6)
SAS Controller
1000BASE-T Adapter
1000BASE-T Adapter (2ch)
1000BASE-T Adapter (4ch)
PCI slot capability
Slot size
PCI board type
*2
Available board size
Upgrading Your Server 9-19
Slot (Bus A)
PCIe #1 *1
x8 lane
LowProfile
x8 socket
MD2
∗1
√
∗1
√
∗1
√
∗1
√
∗1
√
∗1
√
∗1
√
Remarks