9-38 Upgrading Your Server
2.5-inch Disk Model
Take the following steps to connect the cable.
1.
Install the RAID Controller on the PCI riser card.
2.
Connect the SAS cable to hard disk drive bay.
3.
Connect the SAS cable to RAID Controller.
IMPORTANT: Route the cable as shown in the figure below. Make
sure that the cable is not caught.
This completes cable connection.
Install the RAID Controller according to installation steps of PCI board.
K410-188(00) internal SAS cable
Hard disk drive bay
K410-188(00) internal SAS cable
RAID Controller