NEC N8100-1573F User Manual page 328

D-24 Installing Windows Server 2008
8.
Click [TEAM: "Team name"] from [Device manager] → [Network adapters] to modify
the team. Click [Settings] tab and click [Modify Team] button.
9.
Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Point the adapter and click [Set Primary] button.
– Set Secondary
Point the adapter and click [Set Secondary] button.
NOTE:
procedure:
1. Click [TEAM: "Team name"] from [Device manager] → [Network
adapters].
2. Click [Settings] and confirm Adapters in team list.
10.
Click [Test Switch] → [Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results]
Even the system are normal, the following mismatch message will appear sometimes.
Please recheck the switching hub (L2) port and nothing problem with the setting ignore
the messages.
– The switch is configured with aggregated ports, but the team type does not support port
aggregation. The switch is configured with VLAN tagging, but the team has no
VLANs.
– Change the team type to SLA, reconfigure the switch for link aggregation, or disable
VLAN tagging on the switch.
11.
Reboot the system.
Remove Team
1.
Open the [Device Manager].
2.
Click [Network adapters], and open [TEAM: "Team name"] properties.
3.
Click [Setting] tab.
4.
Click [Remove Team] button.
5.
Click [Yes] to the message.
6.
Confirm [TEAM: "Team name"] adapter in not existing in [Network adapters] tree and
reboot the system.
Adapter priority config can be confirmed by the following