Viewing Autoloader Error Codes - ADIC FastStor 2 User Manual

There are unused loops on the belt. The proper belt loops have an extra
NOTE:
bump on the outside of the loop.
8. Ensure the carrier is properly installed on the belt by gently pressing on the top of the carrier
and sliding it back and forth. If it is properly attached to the belt, it should not move. If it does,
reinstall the carrier.
9. Replace the top cover of the autoloader and reinstall the eleven cover screws and mounting
brackets.

Viewing Autoloader Error Codes

If an error occurs during operation of the autoloader, the autoloader stops the current operation and
displays an error code on the top line of the LCD screen. Unless otherwise noted in
attempt to resolve the error by cycling power on the autoloader and retrying the last operation. If the
error persists, contact ATAC (see
To view the most recent error logs and events, see
Table 7-2 provides a description of each of the error codes.
Table 7-2 Error Codes
Error Code Description
80H-8FH
81H Invalid command error
Viewing Autoloader Error Codes
Contacting ATAC).
Viewing Event
Details
Codes within this range indicate robotic control
errors.
This error indicates that the robotics have received
an invalid command issued by the library controller. A
communication failure or non-matching autoloader
code.
Table 7-2,
Logs.
53