Viewing Or Changing The Autoloader Scsi Id; Viewing Or Changing The Tape Drive Scsi Id - ADIC FastStor 2 User Manual

If you changed the SCSI ID, you may also need to cycle power on the host
NOTE:
system and reconfigure your backup software before you can use the
autoloader. Consult your hardware and software manuals for more information.

Viewing or Changing the Autoloader SCSI ID

Use the following procedure to view or to modify the autoloader SCSI ID.
To change the autoloader SCSI ID
1. From the Home Screen or main menu, press + or – until Configuration appears on the top line
of the LCD screen.
2. Press ENTER to select.
3. Press + or – until the Change SCSI ID message appears on the top line of the LCD screen.
4. Press ENTER to select.
5. Press + or – until the Loader message appears on the bottom line of the LCD screen and then
press ENTER to select.
6. Press + or – until the desired SCSI ID is displayed. Press ENTER. Press CANCEL to view only.
The Cycle Power for New SCSI ID message appears on the LCD screen if you have made a
change.
7. Turn off the autoloader. After a few seconds, turn it back on again.
The selected SCSI ID is now in effect.

Viewing or Changing the Tape Drive SCSI ID

Use the following procedure to view or to modify the tape drive SCSI ID.
To change the tape drive SCSI ID
1. From the Home Screen or main menu, press + or – until Configuration appears on the top line
of the LCD screen.
2. Press ENTER to select.
3. Press + or – until the Change SCSI ID message appears on the top line of the LCD screen.
4. Press ENTER to select.
5. Press + or – until the Drive message appears on the bottom line of the LCD screen.
6. Press ENTER to select.
7. Press + or – until the desired SCSI ID is displayed, and then press ENTER. Press CANCEL to
view only.
The Cycle Power for New SCSI ID message appears on the LCD screen if you have made a
change.
8. Turn off the autoloader, and then after a few seconds, turn it back on again.
The selected SCSI ID is now in effect.
38 6-00515-03 Rev A