Viewing Firmware Levels; Displaying Product Version - ADIC FastStor 2 User Manual

3. Press + or – until the View Event Log message appears on the LCD screen.
The LCD screen also displays the errors and events currently stored in the event log.
4. Press ENTER to access logged events.
The most recent entry is number 0 and older entries are negative numbers.
NOTE:
5. Press + or – to display each event in the log.
6. Press CANCEL when done.
The format for the error or event log is displayed as:
Event: 24 (occurance number)
3 (type) 2 (identifier) A0 (autoloader error number)
Up to 64 entries can be stored in the log. The occurance number describes the specific event entry.
The most recent entry is 0 and older entries are shown as negative numbers.
The type values range from 1 to 5:
1. Internal robotic command message received by RobCtrl Module
2. Internal robotic command message received by RobCtrl Module
3. Indicates an error message
4. Represents motion script information
5. Indicates debug output.
Typical identifier values range from 1 to 2:
1. Robotic control messages
2. Robotic test messages.
Refer to Viewing Autoloader Error Codes
numbers generated in the log.

Viewing Firmware Levels

At any time, you can display the current versions of firmware for the overall product as well as the
individual firmware versions on the system.

Displaying Product Version

This option displays the overall product firmware version installed on the autoloader.
Viewing Firmware Levels
for descriptions of the possible autoloader error
43