Vls Error Messages; Error Messages - ADIC VLS AIT Installation And Operating Manual

VLS Error Messages

If any component of the VLS is not communicating correctly, a warning message will appear
on the front display.
A list of error messages follows below. If the error you see is not on this list, please call
ADIC's Customer Assistance Center.
In all cases, after removing the cause of the problem (or if you can't find a cause) push MENU
to return the VLS to the on-line condition.
If the error message is not listed, try to return to the on-line mode by pressing ALT and/or
ENTER. If that does not work or if you get the error again, call ADIC's Customer Assistance
Center and be prepared to tell them what the error message is – and what the conditions are.

Error Messages

Error Name
Source location empty
Destination location full
Mag unload disabled by
software
Can't unload, media in
drive
44
Troubleshooting and Diagnostics
Note
Description
The source location was empty when the VLS attempted to pick
a cartridge from it.
The destination location was full when the VLS attempted to
place a cartridge in it.
The application has issued the SCSI PREVENT/ALLOW
MEDIA REMOVAL command, preventing the magazine from
being unloaded.
The VLS will unload the magazine only if all drives are empty.