Precautions; Protective Devices; Front Power Switch; Regulatory Notices - ADIC FastStor 2 User Manual

• Servicing—Do not attempt to service the product beyond that described in the operating
and installation instructions. All other servicing should be referred to qualified service
personnel.

Precautions

• Do not use oil, solvents, gasoline, paint thinners, or insecticides on the unit or near the unit.
Vapors from these types of chemicals can damage the tape media components.
• Do not expose the unit to moisture or store unit in temperatures higher than 60 ºC (140 ºF),
or to extreme low temperatures. See
temperatures.
• Keep the unit away from direct strong magnetic fields, excessive dust, and electronic/
electrical equipment that generate electrical noise.
• Hold the AC power plug by the head when removing it from the AC source outlet; pulling
the cord can damage the internal wires.
• Use the unit on a firm, level surface free from vibration.

Protective Devices

The FastStor 2 is equipped with the following protective devices:
•

Front Power Switch

Front Power Switch
Switching off the Front Power Switch removes power from the electronics which causes the picker
to stop immediately. This switch also removes power from the drives.
THE FRONT POWER SWITCH FUNCTIONS AS A POWER INTERRUPT
WARNING:
ONLY. TO COMPLETELY REMOVE ALL POWER, DISCONNECT THE AC
LINE CORD FROM THE ELECTRICAL SOURCE.

Regulatory Notices

ADIC libraries are designed, tested, and classified for their intended electromagnetic environment.
These electromagnetic environment classifications generally refer to the following harmonized
definitions:
Class A is typically for business or industrial environments.
Class B is typically for residential environments.
To determine which classification (Class A or B) applies to your tape library, examine all registration
labels located on the bottom, the back panel, or on the inside of the chassis below the magazines.
12
Environment specifications for operating
6-00515-03 Rev A