Prepare Existing Fireplace; Glass Frame Assembly; Remove Glass Frame Assembly; Install Glass Frame Assembly - kozy heat Jackson 911 Installation And Operation Manual

PREPARE EXISTING FIREPLACE

Any removed parts must be capable of reinstallation if this insert is ever removed (removal of rivets or screws is acceptable).
The refractory, glass doors, screen rails, screen mesh and log grates may be removed from existing fireplace before installing this gas
fireplace insert. Any smoke shelves, shields and baffles may be removed if attached by mechanical fasteners. If necessary, remove firebrick
to obtain at least minimum opening requirements.
The fireplace flue damper can be fully blocked open or removed for installation of this gas fireplace insert. Remove existing chimney cap.
Clean chimney and inside of fireplace to prevent creosote smell from entering the home.
Place ‗THIS UNIT HAS BEEN MODIFIED' label at bottom of existing firebox so it will be visible if this gas fireplace insert is removed.
Cutting of any sheet metal parts is prohibited, except the metal floor. If metal floor is removed, the insert must be placed directly on metal
base of metal fireplace.
Run any necessary electrical wiring to insert.
WARNING: DO NOT OPERATE THIS FIREPLACE WITH GLASS REMOVED, CRACKED OR BROKEN. REPLACEMENT
OF GLASS ASSEMBLY, #700-08T SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.
WARNING: DO NOT REMOVE GLASS ASSEMBLY WHEN HOT!

REMOVE GLASS FRAME ASSEMBLY

1. Locate spring-loaded handles securing glass frame assembly at bottom of firebox.
2. Pull bottom handles out and ‗down' to release glass frame assembly bottom.
3. Pull bottom of glass frame assembly out and lift up off tabs at top of firebox.

INSTALL GLASS FRAME ASSEMBLY

A. Place glass frame assembly top over tabs at top of firebox.
B. Pull bottom handles out and ‗up' to secure glass frame assembly bottom.

GLASS FRAME ASSEMBLY

Figure 9a
PAGE 9