Dw6000 Components; Relocating The Dw6000; Preventative Maintenance - Hughes Direcway DW6000 User Manual

DW6000 components

Relocating the DW6000

Preventative
maintenance
2
DW6000 installation and components
Your DIRECWAY System was completely assembled by the professional
installer. Should you need to move the DW6000 to another location, you would
not have to disassemble it. You would simply disconnect the receive, transmit,
and Ethernet cables and unplug it from the power strip or surge protector. Then
move it to the new location and reconnect all the cables as shown in Figure 1.
Be aware that if you move the DW6000 you may have to reroute, or add to, the
coaxial cable that runs from the ground block near the satellite antenna to where
the DW6000 is installed. Check the cable requirements in the satellite antenna
installation manual for your satellite antenna before you do this.
You may not service the coaxial cable that runs from the ground block to the
satellite antenna, or the satellite antenna itself. Only certified professional
installers are allowed to do that.
Ethernet
cable
Transmit cable
(Satellite Out)
Figure 1: DW6000
Keep the convection cooling vents free from blockage. Dust the unit as often as
needed with a soft, damp cloth. Do not use solvent or abrasive powder when
cleaning.
No internal cleaning or service is required. The DW6000 does not contain user
serviceable parts. Opening or tampering with the unit will void its warranty.
AC power
cord
Surge protector
Power
supply
DC power
cord
Receive cable
(Satellite In)