Example 2: Gain Of The Amplifier In The Metering Circuit - Owon PDS5022S User Manual

User's Manual of OWON Colour Digital Storage Oscilloscope

Example 2: Gain of the Amplifier in the Metering Circuit

Set the probe menu attenuation coefficient as 10X and that of the switch in the probe
as 10X.
Connect the oscilloscope CH1 channel with the circuit signal input end and the CH2
channel to the output end.
Operation Steps
1. Push down the AUTOSET button and the oscilloscope will automatically adjust
the waveforms of the two channels into the proper display state.
2. Push down the MEASURE button to show the MEASURE menu.
3. Press the F1 menu selection button and choose Source.
4. Press the F2 menu selection button and choose CH1.
5. Press the F3 menu selection button and choose CH2.
6. Press the F1 menu selection button again and choose Type.
7. Press the F2 menu selection button and choose Pk-Pk.
8. Press the F3 menu selection button and choose Pk-Pk.
9. Read the peak-to-peak values of Channel 1 and Channel 2 from the displayed
Fig.64 Waveform of Automation Measurement
73