To Perform The Function Inspection - Owon PDS5022S User Manual

User's Manual of OWON Colour Digital Storage Oscilloscope

To perform the Function Inspection

Make a fast function check to verify the normal operation of the instrument, according
to the following steps:
1. Connect the Instrument to the Power and Push down the Power Switch Button.
The instrument carries out all self-check items and shows the prompt "Press any Key
Enter the Operating Mode". Press the "UTILITY" button to get access to the
"FUNCTION" menu and push down F2 the menu selection button to call out the
function "Recall Factory". The default attenuation coefficient set value of the probe in
the menu is 10X, shown as Fig.4.
2. Set the Switch in the Oscilloscope Probe as 10X and Connect the
Oscilloscope with CH1 Channel.
Align the slot in the probe with the plug in the CH1 connector BNC, and then tighten
the probe with rotating it to the right side.
Connect the probe tip and the ground clamp to the connector of the probe
compensator, shown as Fig.5.
Fig.4 Power on the Instrument
14