User's Manual of OWON Colour Digital Storage Oscilloscope
The description of the Channel Menu is shown as the following list: following
form:
Function Menu
Coupling
Channel
Probe
Inverted
1.
Setting Channel Coupling
Taking the Channel 1 for example, the measured signal is a square wave signal
containing the direct current bias. The operation steps are shown as below:
(1). Press the CH1 MENU button and call out the CH1 SETUP menu.
(2). Press the F1 menu selection button and select the Coupling item as "AC" to
set the channel coupling as ac mode, under which the direct current
component in the signal will be blocked.
Then, press the F1 menu selection button again and select the Coupling item as
"DC", setting the channel coupling as DC mode, under which both dc and ac
components in the signal will be unblocked.
The waveforms are shown as Fig.15 and Fig.16.
Setting
Description
AC
Block the DC component in the input signal.
DC
Unblock the AC and DC components in the
input signal.
Ground
Input signal is interrupted.
OFF
Close the measurement channel.
ON
Open the measuring channel.
1X
Choose
10X
attenuation factor to make the vertical scale
100X
reading accurate.
1000X
OFF
The wave form is displayed normally.
ON
Initiate the wave form inverted function.
25
one
according
to
the
probe