Interfaces - NetComm NTC-40WV User Manual

Hspa+ m2m wifi router with voice
Hide thumbs Also See for NTC-40WV:
Table of Contents

Advertisement

Interfaces

The following interfaces are available on the NTC-40WV:
1
ITEM
1
Diversity Receive 3G Antenna
2
SIM Card Reader Tray Eject button
3
SIM Card Reader Tray
4
Main 3G Antenna
1
ITEM
1
WiFi Antenna Port
2
Captive Power Terminal
3
RJ-11 Telephone Cable Port
4
RJ-45 Ethernet Port
5
Reset button
6
WiFi Antenna Port
NTC-40WV HSPA+ M2M WiFi Router with Voice
10
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
2
Figure 5 - Bottom Mounted interfaces
INTERFACE
Table 6 - Bottom Mounted interfaces
2
Figure 6 - Top Mounted Interfaces
INTERFACE
Table 7 - Top Mounted interfaces
3
Connect one of the 3G antennas here
Push in with a paper clip to eject the SIM card reader tray.
Insert the SIM Card reader tray with a SIM inserted here.
Connect one of the 3G antennas here.
3
4
Connect one of the WiFi antennas here.
Connect the supplied power cable here.
Connect a PSTN telephone here in order to make calls via the 3G connection.
Connect an Ethernet cable here.
To reboot the router push and hold the reset button for one second to reboot the
NTC-40WV.
To boot the router into system recovery mode hold the reset button for approximately
10 seconds until the LEDs on the front of the router start to flash in an on/off sequence
and then release it.
Connect one of the WiFi antennas here.
4
FUNCTION
5
6
FUNCTION
www.netcommwireless.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hspa+ m2m wifi router

Table of Contents